SILVER SEQUIN STYRO BALL (page 16)
Reading edition
SILVER SEQUIN STYRO BALL (page 16)
You’ll need:
3 yds. Wright’s sequin trim 9871, silver ¾ yd. satin ribbon, rose 1¼ yds. satin ribbon, aqua ⅓ yd. satin ribbon, orchid 1 styrofoam ball, 4″ diameter
To make:
1. Mark ball into ¼ sections; pin rose ribbon over markings.
2. Cut and pin aqua ribbon strips to fill ¼ sections. Cut 3″ strips orchid ribbon, pointing ends, and pin to center of each ¼ section.
3. Pin sequin trim around edge of orchid section; repeat at edges of rose ribbon. Pin 5 separate sequins down center of each orchid section.
4. For top loop, insert pins in opposite directions into ball at both ends of 6″ sequin trim.