ALPHABETICAL REFERENCES TO DRAWINGS.

A Driving Pulley, 8 in. to 18 in. dia., advancing by 1/2 in. increments, 3-1/4 in. face.

A¹ Cylinder Gear, 21, 25, 29, 30, 39 and 49 T.

A² Cylinder, 7 in. and 8 in. dia.

B Jack Gear, 72, 76, 80, 84, 86, 96 and 106 T.

B¹ Twist Change Gear, 25 to 67 T., advancing by one tooth.

C Intermediate Gear, 171 T.

C¹ Builder Motion Driving Sprocket Gear, 8 T.

D Front Roll Twist Gear, 108 and 92 T., Single Line Bottom Roll. Head End Stud Gear, 108 T., Double Line l Bottom Rolls.

D¹ Head End Stud Change Gear, 23, 27, 32 and 36 T.

E Front Roll Change Gear, 36, 32, 27 and 23 T.

E¹ Front Roll Gear, 39 T.

E² Front Roll, 1-1/2 in. dia.

F Back Roll Intermediate Gear, 48 T.

G Back Roll Gear, 40 T.

G¹ Back Roll, 1-1/2 in. dia.

H Top Roll, 2-1/2 in. dia.

I Whorl, 7/8 in., 1-1/8 in., 1-3/8 in., 1-5/8 in. and 2-1/2 in. dia.

J Carrier Sprocket Gear, 10 T.

K Builder Motion Worm Shaft Sprocket Gear, 12, 14, 16, 18, 20, 22 and 24 T., dependent upon the Number of Yarn.

L Carrier Sprocket Gear, 7 T.

NOTE—For Letters A and I refer to Spinning Frame cut on page 161.

{206}