ALPHABETICAL REFERENCES TO DIAGRAM.
Reading edition
A Electric Roll Gear, 24 Teeth for Common Rolls, 20 Teeth for Metallic Rolls.
B Off End Back Roll Gear. 24 Teeth for Common Rolls, 29 Teeth for Metallic Rolls.
*C Small Double Intermediate, driving 3d Roll.
D Large Double Intermediate, driving 3d Roll, 40 Teeth for Common Rolls, 36 Teeth for Metallic Rolls.
E Off End 3d Roll Gear, 24 Teeth.
*F Off End 2d Roll Gear.
*G Small Double Intermediate, driving 2d Roll.
*H Large Double Intermediate, driving 2d Roll.
I Off End Front Roll Gear, 20 Teeth.
J Back Roll Gear, 45 to 80 Teeth.
K Draft Change Gear, 45 to 70 Teeth.
*L Crown Gear.
*M Front Roll Gear.
NFront Roll Calender Driving Gear, 16 Teeth for Common Rolls, 19 Teeth for Metallic Rolls.
O and P Double Intermediate Gear, 52 and 91 Teeth for 10-in. Coiler, 62 and 108 Teeth for 12-in. Coiler.
Q Calender Roll Gear, 58, 59, 60 Teeth for Common Rolls, 52, 53, 54 Teeth for Metallic Rolls.
R Coiler Horizontal Shaft Gear, 21 to 26 Teeth (driven by O through Carrier Gear).
S Tube Wheel, 75 Teeth for 10-in. Coiler, 98 Teeth for 122 in. Coiler.
T Coiler Vertical Shaft, Top Bevel Gear, 32 Teeth for 10 in. Coiler, 37 Teeth for 12-in. Coiler.
NOTE—For teeth on gears marked * refer to table on page 96.
{94}