Part 1 — To Re-sole Cashmere Stockings.

Stockings re-soled according to the following directions can be worn with slippers, and will be found comfortable.

Fig. 1.

Place the stocking as shown in Fig. 1, cut off the sole at the dotted line a—b; then cut off the toe at the line c—d. As the heel of the sole piece will not lie flat it must be slit, until, when laid out, it resembles fig. 2. Cut pieces to these patterns from the leg of another stocking, allowing turnings as follows:

Fig. 2.

Fig. 1, the toe piece, ½-inch at c—d where it joins the stocking; fig. 2. ½-inch all round except at the lines a—b, c—b, where ¼-inch only must be allowed. If the stocking is short this can be remedied by leaving the extra length required at fig. 1, a, and fig. 2, d, in addition to the turnings previously mentioned.

Machine the new toe piece to the stocking at c—d (fig. 1), open and press the seam. Machine a—b to b—c, of the sole piece (fig. 2), open and press the seam. Machine this new sole to the stocking, open and press the seam. Fasten down all seams with small slip stitches.

It is advisable to use mercerised cotton or silk, and to leave the tension of the machine rather slack.