Note 25 — PART I SPECIFICATIONS FOR STREET ROADWAY PAVEMENTS

There is still a wide difference of opinion as to the advisability of laying the asphalt surface directly against the rail, many engineers preferring to set one or more courses of paving brick, or stone paving blocks between the rail and the edge of the asphalt. The writer’s experience is to the effect that, if the work is properly done, the first-named form of construction is preferable. If the asphalt be laid against a rail so cold that the asphalt material in contact with or near the rail is chilled before it can be compressed, the work will necessarily be unsatisfactory. As to durability, wheels following the line of the rail or of the paving blocks will sooner or later form a rut in the asphalt which will require repair—and there is not much difference in the results. The attempts to prevent the formation of ruts by setting blocks alternately as headers and stretchers is not always successful, even when the work is well done, and the difficulty of properly compressing the tongues of asphalt between the headers is so great that it is usually not well done. The asphalt settles under travel or is gouged out, leaving a streak of rough pavement, and the difficulty and cost of repairs is considerably increased. When paving blocks or bricks are used, they should be firmly and carefully set in the concrete foundation. Probably the most satisfactory construction of this kind consists of two or three lines of the best paving brick set with their length parallel to the rail. It is somewhat easier to get at and repair rail joints with this construction.