← Table of contents
Ocean Steamships

Note 11 — SPEED IN OCEAN STEAMERS. By A. E. SEATON.

Reading edition

More than thirty years ago this matter had been observed by the officers of the British navy, and experiments were ordered to be tried with H. B. M. S. Flying Fish, a 1,100-ton cruiser, her length being 200 feet, breadth 30 feet 4 inches, and her draft of water 10 feet 6 inches forward and 13 feet aft. With 1,290 I. H.-P. her speed was only 11.64 knots, whereas with 577 I. H.-P. it was 9.923 knots, and a speed of 11.201 was obtained with but 878 I. H.-P. A false bow 18 feet long was then fitted, so as to give finer lines forward, or, as sailors describe it, “a better entrance,” when it was found that with 1,285 I. H.-P. a speed of 121⁄2 knots was attained, and with 1,345 very nearly 123⁄4 knots. There is also every reason to suppose that could the stern have been altered in a similar way, the speed would have been still higher, in spite of the ship being larger and with a consequent increase of immersed surface to cause resistance. It has, besides, been observed on many occasions that when steamers have been cut in two and lengthened there has been no diminution of the speed, but, on the contrary, in some cases there has actually been a gain; so that in these two instances there is an apparent anomaly, viz., that with the same power the larger ship is propelled at a quicker speed.

The late Dr. Froude investigated this matter some years ago, and showed that such results were quite possible, independently of any fining of the lines, owing to the effect on the ship of the waves set up when in motion. One very curious illustration of how such waves may seriously affect a vessel is in that of a yacht built many years ago by an eminent firm on the Clyde, which failed to come anywhere near the performances guaranteed owing to the fact that as the speed increased the hollow following the wave formed at the bow increased and approached nearer and nearer to the paddle-wheels, until the water dropped below the floats and allowed the wheels to spin in the air; the propelling effect was thus entirely lost until the vessel slowed down sufficiently for the water to rise again to the level of the paddle-wheels. Such a thing could scarcely happen with a screw steamer; but the very bad steering qualities of certain naval ships is due to the fact that the inrush of water at the stern causes currents to flow with the ship, and therefore to produce quite different results with the rudder from those which generally obtain.

Explore with AITake your curiosity a little further.

Reading settings